SOLD OUT Harnesses Due back Mid May 2021

directed electronics RSS

alarm, directed electronics, engine, install, Installation, mazda, miata, motocarr, remote start, starter, tips -

   Hopefully you aren't starting with an ignition harness like this..........it's obvious that there has been something installed here before based on the butt connectors(which should never be used on an ignition harness in my opinion) so we will need to clean this up as we go. Remote Start Pre-wire I typically like to do some wiring of the remote start before I actually install it in a car.  Essentially remove and or cap off wires that will not be used during the installation, as well as making as many connections as possible of ignition/immobilizer bypasses and interfaces.  I'm trying...

Read more

directed electronics, engine, install, Installation, mazda, miata, motocarr, remote start, starter, tips -

What is a remote start? Wikipedia sums it up as a radio controlled device, which is installed in a vehicle by the factory or an aftermarket installer to preheat or cool the vehicle before the owner gets into it. Once activated, by pushing a button on a special keychain remote, it starts the vehicle automatically for a predetermined time. Different models have keyless entry as well. Most newer vehicles need some kind of bypass module to bypass the factory anti-theft system, so the vehicle can be started without the ignition key in the ignition, this is bypassed only to start the vehicle,...

Read more

alarm, directed, directed electronics, engine, install, Installation, mazda, miata, motocarr, remote start, starter, tips -

Quick and easy remote start install done on a 1990 Mazda Miata. Unit used is a 24921 Ready Remote Remote Start made by Directed Electronics.Couple things to note:-We did not install a hood pin because the battery is in the back-Door locks not mentioned because this car has manual locks.

Read more