install RSS

300zx, coilover, install, nismo, nissan, non-turbo, specs, tein, torque, turbo -

Quick overview on how to assemble Tein's 300zx Street Advance Coilover First bask in all it's green glory for motivation, then pull your stock suspension.(There are writeups all over the internets)  You're going to need your/a stock bumpstop for this install(Or buy new if yours have totally disintegrated.) Note that there is a notch that the threaded body has to sit in.  Remember to check and make sure that it is seated like this when you go to put the top hat on.  It just rests here so as you assemble the coilover it is likely to move around and...

Read more

amp, amplifier, audio, car, diy, g35, infiniti, install, OEM, Radio, sedan, stock -

This isn't a super detailed write up, I'm going to assume you are somewhat handy with basic tools and aren't afraid to get your hands dirty.  Install being performed on a 2004 Infiniti G35X sedanOk here we go!Tools I needed Plastic pannel tool Screwdriver Knife wire strippers solder and soldering iron Electrical tape Parts needed Amp kit w/ RCAs Line out converter (LOC) RCA Bass knob(Optional) Installation Steps Break open you shiney new amp kit. I just went with the power kit because I already had RCAs:Take the battery cover offAll the covers come off by popping the middle of...

Read more

alarm, directed electronics, engine, install, Installation, mazda, miata, motocarr, remote start, starter, tips -

   Hopefully you aren't starting with an ignition harness like this..........it's obvious that there has been something installed here before based on the butt connectors(which should never be used on an ignition harness in my opinion) so we will need to clean this up as we go. Remote Start Pre-wire I typically like to do some wiring of the remote start before I actually install it in a car.  Essentially remove and or cap off wires that will not be used during the installation, as well as making as many connections as possible of ignition/immobilizer bypasses and interfaces.  I'm trying...

Read more

directed electronics, engine, install, Installation, mazda, miata, motocarr, remote start, starter, tips -

What is a remote start? Wikipedia sums it up as a radio controlled device, which is installed in a vehicle by the factory or an aftermarket installer to preheat or cool the vehicle before the owner gets into it. Once activated, by pushing a button on a special keychain remote, it starts the vehicle automatically for a predetermined time. Different models have keyless entry as well. Most newer vehicles need some kind of bypass module to bypass the factory anti-theft system, so the vehicle can be started without the ignition key in the ignition, this is bypassed only to start the vehicle,...

Read more

alarm, directed, directed electronics, engine, install, Installation, mazda, miata, motocarr, remote start, starter, tips -

Quick and easy remote start install done on a 1990 Mazda Miata. Unit used is a 24921 Ready Remote Remote Start made by Directed Electronics.Couple things to note:-We did not install a hood pin because the battery is in the back-Door locks not mentioned because this car has manual locks.

Read more